Keg washer Re-2 with manuel valves
Application:
Usable for washing, disinfecting with steam and pre-pressurisation with CO² of all types of KEGs (DIN, EURO, SCHLANK-Keg, ECO-Keg, etc.), equipped with flat, combi or Sankey-type fittings.The capacity of the KEG-washer is depending on the degree of soilage - approx. 10 KEGs per hour.
Material:
The KEG-washer is built completely in stainless steel, with EPDM seals; the KEG-holding device is made in a special plastic.
Construction:
Mounted on the base frame you find:
- 2 washing solution tanks (1 for hot caustic soda, 1 for an acid disinfectant)
- 2 stainless steel pumps
- the KEG holding device with the washing head
- the piping with the manually operated butterfly valves.
- The electronic control panel (including the thermostat, probe for protection of the heating pole against overheating, “KEG-ready-probe”, pump dry-run-protection) is located in the separate box.
WORK PHASES:
- Depressurisation of the KEG and drain rest of the beer into the channel
- Pre-rinsing with cold or hot water
- Cleaning with hot caustic soda
- Intermediate rinsing with cold or hot water
- Cleaning / Disinfection with acid disinfectant
- Rinsing
- Sterilisation with steam
- Pressurisation with CO²-gas
TECHNICAL DATA:
Power Requirement:10 A; 220 V
Water Requirement:Min. 1/2”; 3 bar, warm or cold water supply, floor drain for waste water
Measurements (in mm):1000 mm x 700 mm x 1300 mm